Are you searching for a perforated pre-press belt for an MDF, HDF or particleboard production line? What if the original technical drawing is missing ?
This is a familiar challenge for maintenance and purchasing teams. A replacement belt is needed, but the original supplier's records may be incomplete, and the old belt may already be worn or damaged.
Before giving up on the project, it helps to understand two things: why the belt is perforated and what information can be used to reproduce it.
A loose wood-fiber or particle mat contains air between the raw materials after forming.
During pre-pressing, the mat is compressed to reduce its thickness and improve its stability before entering the hot press. At the same time, the air inside the mat needs a route to escape.
The openings in a perforated pre-press belt provide passages for air through the belt. When the belt is used with a suitable machine ventilation or extraction arrangement, the design can support air release during compression.
This is why the hole design is an important part of the belt specification, rather than just a visual feature.
A replacement belt should match the machine and working conditions. Here are five important points.
1. Overall belt dimensions
Confirm the belt width, total length or circumference, and thickness. If possible, provide both the measured dimensions and the machine's original specifications.
2. Hole diameter and spacing
The hole diameter, pitch, arrangement and distribution should be checked. If you cannot measure them precisely, take close-up photos with a ruler beside the holes.
3. Belt construction
The surface material, reinforcement structure and flexibility should suit the required pre-press application.
4. Joint details
Provide photos of the joint and confirm its position, construction and any special running requirements.
5. Machine and operating information
The machine model, pulley diameter, tensioning arrangement, operating speed and production material can all help with specification review.
Yes, in many cases the assessment can begin without a complete drawing.
The following materials are useful:
Machine manufacturer and model
Belt width, length or circumference, and thickness
Photos of the old belt from both sides
Close-up photos of the perforations and joint
Photos of the belt installed on the machine
Any previous quotation, specification sheet or purchase record
Based on these details, the belt construction and key dimensions can be reviewed. A proposed drawing can then be prepared for your confirmation before production.
Both products are related to air management in wood-based panel production, but they may have different structures and installation positions.
A perforated pre-press belt supports mat conveying and compression while allowing air to pass through its openings.
A dedicated airing or deaeration belt is designed for airflow management in its own process position. The two should be selected according to the actual machine layout.
Related product information:
Pre-press Belt with Perforated
Pre-press Belt without Perforated
Deaeration Belt with Carbon Fiber
Deaeration Belt with Copper Wire
You do not need to wait until every technical detail is available.
Start with the machine model, basic belt dimensions and clear photos. If the hole pattern or joint details are uncertain, these can be reviewed during the drawing-confirmation stage.
Are you replacing an existing perforated pre-press belt, or sourcing one for a new machine?
Share the information available, and the replacement specification can be reviewed step by step.
व्यक्ति से संपर्क करें: Mr. Maple
दूरभाष: +86 17778255675
फैक्स: 86--311-80690567